Ref: 629
Brand: ModMaker
Atty stand 510s with glue grooves for better adhesion inside stand material.
Ref: 613
Brand: ModMaker
Mosfet board with on off feature and protection
Ref: 241
Brand: ModMaker
A sheet of 67mm X 8mm vinyl stickers with permanent adhesive designed to fit into Keystone 18650 battery sled apertures although they can be used anywhere that you need to clearly show the orientation of a battery.
Ref: 711
Brand: ModMaker
The 2nd Generation MM510 Standard Version
Ref: 555
Brand: ModMaker
Large positive nut for the MM510 Squonk version.
Ref: 25
Very popular silver tactile switch with a sphere actuator measuring approx 4mm diameter.
ModMeter V2. The P-Channel voltmeter, ohm meter wattage calculator board.
Privacy policy
Delivery Information
Return / Refund Policy
ModMeter V2 it the all in one display that will show you the wattage, amperage, resistance, voltage under load and battery voltage of your mod. This Ohm's law calculation chip set doesn't carry any current so it will work perfectly with high current builds so no more limits on your super sub ohm high current setups.
ModMeter works perfectly with P-Fet builds, OKL, OKR & Raptor builds. It does work with PWM but the numbers are funky because of the nature of PWM with the Voltage Out jumping around. Battery levels and resistance are true though and are unaffected by the PWM signal.
Please note that ModMeter does NOT work with N-Channel mosfet builds as the meter acts like a bridge and will make the mod fire when connected.
Ref: 12
Prototype PCB Universal Experiment Matrix Circuit Board measuring approx 70mm x 50mm
ModMeter V2. The P-Channel voltmeter, ohm meter wattage calculator board.
