Ref: 629
Brand: ModMaker
Atty stand 510s with glue grooves for better adhesion inside stand material.
Ref: 241
Brand: ModMaker
A sheet of 67mm X 8mm vinyl stickers with permanent adhesive designed to fit into Keystone 18650 battery sled apertures although they can be used anywhere that you need to clearly show the orientation of a battery.
Ref: 613
Brand: ModMaker
Mosfet board with on off feature and protection
Ref: 555
Brand: ModMaker
Large positive nut for the MM510 Squonk version.
Ref: 25
Very popular silver tactile switch with a sphere actuator measuring approx 4mm diameter.
Ref: 692
Brand: ModMaker
510 drip tip blanks made from 304 stainless steel.
12mm LED Switch
Privacy policy
Delivery Information
Return / Refund Policy
Fantastic little black anodized aluminum clicky LED switches. Probably the smallest 12mm LED switch on the market. Simple to connect. The LED is independent of the switch so there are 4 terminals. The LED is controlled by the + & - terminals.
The LED is quite forgiving but will need a resistor to the LED. As a very general rule, a 220R is good for 1 battery (3.7v), a 470R for 2 batteries (7.4v) and higher than that jump in around 200R increments.
Ref: 244
Momentary switch made from stainless steel. Not to be confused with the miTEC and miTEC style clicky switches.
Ref: 316
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 237
Brand: miTEC
These momentary miTEC switches must have the smallest footprint of any 12mm switches I've seen. The action is clicky too so much like a tactile switch. They are made of stainless steel and ooze quality. Perfect for tight builds where you want a switch bigger than a tactile switch.
Ref: 283
Momentary switch. Not to be confused with the smaller miTEC style clicky switches.
Ref: 451
Very similar to the Otto P9 switches found on the HexOhm mods
Ref: 295
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 328
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
12mm LED Switch
