- Out-of-Stock

Ref: 629
Brand: ModMaker
Atty stand 510s with glue grooves for better adhesion inside stand material.
Ref: 25
Very popular silver tactile switch with a sphere actuator measuring approx 4mm diameter.
Ref: 613
Brand: ModMaker
Mosfet board with on off feature and protection
Ref: 555
Brand: ModMaker
Large positive nut for the MM510 Squonk version.
Ref: 692
Brand: ModMaker
510 drip tip blanks made from 304 stainless steel.
12mm stainless steel clicky LED switches.
Privacy policy
Delivery Information
Return / Refund Policy
Fantastic little stainless steel clicky LED switches. Probably the smallest 12mm LED switch on the market. Simple to connect. The LED is independent of the switch so there are 4 terminals. The LED is controlled by the + & - terminals.
The LED is quite forgiving but will need a resistor to the LED. As a very general rule, a 220R is good for 1 battery (3.7v), a 470R for 2 batteries (7.4v) and higher than that jump in around 200R increments.
Ref: 237
Brand: miTEC
These momentary miTEC switches must have the smallest footprint of any 12mm switches I've seen. The action is clicky too so much like a tactile switch. They are made of stainless steel and ooze quality. Perfect for tight builds where you want a switch bigger than a tactile switch.
Ref: 469
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 318
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 316
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 283
Momentary switch. Not to be confused with the smaller miTEC style clicky switches.
Ref: 294
Great little miTEC style clicky switches. Ultra low footprint so good for tight builds.
Ref: 451
Very similar to the Otto P9 switches found on the HexOhm mods
12mm stainless steel clicky LED switches.